Heating & AC 30 Point Tune Up in Atlanta, GA | Free Download

30 Point Heating Maintenance

Here’s what we do that sets us apart

• High Resolution (1080 dp) Deep Internal Furnace Scan
• Inspect heat exchanger and vacuum out minor rust deposits
• Pull Blower assembly or inspect the blower wheel and motor
• Visual inspection of evaporator coil
• Inspect and clean burners
• Vacuum out minor rust around burners
• Check ignition controls
• Clean flame sensor
• Measure temperature rise
• Measure blower amps
• Check blower capacitor
• Inspect flue pipe
• Test main limit switch
• Test flame rollout switches
• Test all Safety controls
• Test gas valve operation
• Check gas connections at furnace
• Check and adjust gas valve pressure (if necessary)
• Test fan control
• Test door switch
• Check and tighten all electrical connections
• Check and tighten low voltage connections
• Measure high voltage to furnace
• Test inducer assembly
• Test pressure switch
• Check thermostat operation
• Inspect ductwork
• Replace standard 1 inch pleated filter
• Update inspection label
• Clean up after completion of tune-up

30 Point Cooling Maintenance

Here’s what we do that sets us apart

• High Resolution (1080 dp) Deep Internal Scan
• Camera scan blower assembly, inspect the blower wheel and motor
• Check blower capacitor
• Measure blower amps
• Inspect heat exchanger
• Inspect evaporator coil
• Check refrigerant charge
• Tighten all refrigerant service valve caps and covers
• Inspect condenser coil
• Clean out debris from bottom of condenser
• Inspect fan blade
• Flush condensate drain line
• Check all drain safety switches
• Check condensate pump and line (if applicable)
• Measure temperature difference across evaporator coil
• Check low and high pressure switches
• Test high voltage at disconnect and condenser
• Check and tighten all electrical connections
• Check and tighten all low voltage connections
• Measure compressor mega ohms
• Measure compressor amps
• Measure fan amps
• Test compressor run and start capacitors
• Check compressor terminal connections
• Check thermostat operation
• Replace standard 1 inch pleated filter
• Inspect ductwork
• Inspect flue pipe
• Update inspection label
• Clean up after tune-up